INSUFFICIENT TRANSMISSION TALK POWER IN SSB MODE

By SM0TER

Extracts from KENWOOD Service Technical Report
         No. E51-89-002 date FEB 10 1989

The talk power of the TS-790 is lower than previous models i.e. TR-851 and TS-811.

Not all versions of the RIG suffer from this problem. I have the TS-790A and the following modification was done when I purchased the RIG.

The report was sent to the following TRIO-KENWOOD offices.

T-K CANADA
T-K AUSTRALIA
T-K NV,SA

The following is quoted from the Service Report.

To boost the talk power of the TS-790 to almost the same level of the former models surpress the ALC response like the former models.

Connect a 0.039 to 0.047 uF between pins 6 and GND of IC201 on the ALC amplifier daughter unit (X59-3480-00 (F)).

*NOTE:This above alteration distorts the SSB transmission signal quality. Thus the alteration will not be applied to mass production.

End of quote.

The mode was done on my RIG from the factory and I have had no reports of poor audio!!

The following white noise check is shown in the Service Report.

ORGINALALTERED
Low ALC level1 to 1.5 W2.5 to 3.0 W

Click here to read more mods for the TS-790